Section R9-14-613. Solid Waste Compliance Testing

A.      A licensee for a laboratory at which solid waste compliance testing is performed shall ensure that each solid waste sample for Arizona compliance testing is analyzed using an approved method:

1.        Listed under Exhibit I, Table 1, Section C, Solid Waste Parameters; or

2.        Approved by the Department for solid waste compliance testing under R9-14-610(C).

B.       A licensee for a laboratory at which solid waste compliance testing is performed using an 8000 series method from Key Reference F shall:

1.        If the method includes specific quality control require- ments, follow the specific quality control requirements in the method;

2.        If the method does not include specific quality control requirements, follow all requirements in EPA, Method 8000C: Determinative Chromatographic Separations (rev. 3 March 2003), incorporated by reference, on file with the Department, including no future editions or amend- ments, and available at http://www.epa.gov/epaoswer/ hazwaste/test/new-meth.htm; and

3.        If the method does not include specific sample extraction procedures, follow the procedures in the following from Key Reference F, as applicable:

a.         Method 3500B,

b.        Method 3600C, and

c.         Method 5000.

C.      A licensee for a laboratory at which solid waste compliance testing is performed using a non-8000 series method from Key Reference F shall comply with the following from Key Refer- ence F, as applicable according to the requirements of the spe- cific method:

1.        Method 4000, and

2.        Method 7000A.

D.      A licensee for a laboratory at which solid waste compliance testing is performed using a method from Key Reference F shall comply with Chapters 1 through 8 of Key Reference F, as applicable according to the requirements of the specific method.

Historical Note

Adopted effective December 20, 1991 (Supp. 91-4). For- mer Section R9-14-613 renumbered to R9-14-614; new Section R9-14-613 renumbered from R9-14-612 and amended effective June 20, 1997 (Supp. 97-2). Former Section R9-14-613 renumbered to R9-14-615; new Sec- tion R9-14-613 renumbered from R9-14-611 and amended by final rulemaking at 7 A.A.R. 184, effective December 15, 2000 (Supp. 00-4). Amended by final

rulemaking at 12 A.A.R. 4798, effective December 5,

2006 (Supp. 06-4).