Section R4-34-603. Factory-built Buildings and FBB Subassemblies

A.      A manufacturer shall construct a factory-built building or a FBB subassembly according to the applicable standards in R4- 34-102(2) and:

1.        Provide a complete set of drawings and specifications to the Department under R4-34-703(B);

2.        Affix a permanent serial number to each unit during the first stage of manufacturing. If a unit has multiple sec- tions, the manufacturer shall ensure that each section is separately identified. The serial number location and application method shall be shown in the plans required under R4-34-703(B)(7); and

3.        Affix an Arizona Insignia of Approval to each completed section. The insignia shall indicate the unit serial number and plan approval number, and be located on the unit as indicated in the plans required under R4-34-703(B)(8).

B.       A manufacturer of a non-residential factory-built building or a FBB subassembly shall comply with 10 A.A.C. 3 relating to the Americans with Disabilities Act Accessibility Guidelines (ADAAG).

C.      The Department may require that a manufacturer of a factory- built building or FBB subassembly produced and shipped before plan approval remove the unit from this state and remove insignias based on the following factors:

1.        Probable harm to the public’s safety and welfare,

2.        Number of previous violations of a similar nature, and

3.        Unwillingness of the manufacturer to comply with plan submittal and requirements.

Historical Note

Adopted effective January 31, 1979 (Supp. 79-1).

Amended effective July 3, 1991 (Supp. 91-3). Section repealed by final rulemaking at 6 A.A.R. 47, effective December 8, 1999; new Section adopted by final rulemaking at 6 A.A.R. 145, effective December 8, 1999 (Supp. 99-4). Amended by final rulemaking at 14 A.A.R.

286, effective March 8, 2008 (Supp. 08-1). Amended by

final rulemaking at 18 A.A.R. 944, effective June 4, 2012

(Supp. 12-2).